Transmission with a new main control, record the solenoid strategy Prior to installing a new transmission or an overhauled Refer to: Transmission Fluid Cooler - Backflushing and Cleaning (307-02A Transmission Cooling - 10-Speed Automatic Transmission – 10R60, General Procedures). Transmission fluid cooler backflushing and cleaning procedure. Installing a new or re-manufactured transmission, carry out the If the transmission is to be overhauled or if If necessary, remove the bolts and the transmission support bracket.įailure to clean the transmission fluid cooler tubes can result in transmission failure.
If installing a new or re-manufactured transmission, remove the transmission support bracket. Slide the transmission back enough to install the special tool and remove the transmission from the vehicle. Remove the LH bellhousing bolt and studbolts. Use the General Equipment: Magnetic Socket Using a magnetic socket, remove and discard the torque converter nuts.
Index mark one stud and the flexplate for assembly reference. Only rotate the crankshaft in a clockwise direction. Rotate the locking arm up and disconnect the transmission electrical connector. Refer to: Transmission Support Insulator (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).ĭisconnect/connect the connector or damage to the connector/wire harnessĭisconnect the electrical connector, wirning harness retainers and position aside the wiring harness. Remove the transmission support insulator.
Separate the flex coupling from the transfercase / transmission flange. Remove and discard the driveshaft flex coupling to transmission flange bolts. Mark the driveshaft flex coupling to the transmission flange. Position and support the driveshaft aside. Take extra care not to damage the component. Refer to: Transfer Case (307-07B Transfer Case, Removal). Use the General Equipment: Transmission Jack Using a high-lift transmission jack and wooden blocks, support the transmission. Secure the transmission to the transmission jack with a safety strap. Remove and discard the bolts and position aside the cable assembly.
#How to install transmission with jack manual#
Position aside the park manual release cable.ĭisconnect the rod from the manual control lever. Remove the bolt, nuts and position aside the transmission fluid cooler. Install the transmission fluid pan and the bolts. It is not necessary to torque transmission fluid pan bolts at this time. Remove the bolts, studbolts and the transmission fluid pan. Note the location of the bolts and studbolts for assembly. Transmission is necessary, drain the transmission fluid. If transmission disassembly or installation of a new Refer to: Starter Motor (303-06B Starting System - 3.0L EcoBoost, Removal and Installation). Remove the push pins and the engine rear shield. Remove the bolts and the underbody shield. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). With the vehicle in NEUTRAL, position it on a hoist. Motorcraft® MERCON® ULV Automatic Transmission Fluid Ford Explorer 2020-2022 Service Manual / Powertrain / Automatic Transmission / Automatic Transmission - 10-Speed Automatic Transmission – 10R60 / Removal and Installation - Transmission - 3.0L EcoBoost
0 kommentar(er)
